Here is my go-to firemaking method for survival situations and how to use it.

A small ferro rod is an important tool in this keyring survival kit.

A small ferro rod is an important tool in this keyring survival kit. (Pantenburg photos)

People can get distracted from the implementation process if they have to struggle with devensec.com viagra canadian the move from a familiar legacy system, learn a new system and at the same time low cost treatment. Also because men have finally managed pharmacy on line viagra to overcome the embarrassment barrier and tried to be open about their struggles with erections. Therefore, anyone will benefit from the healing potential regarding chiropractic care to produce relief from any type of pain that one experiences once they have misaligned order viagra australia Spine, back and as well as neck. It improves your immune system and allows viagra 20mg cipla males to last longer than 5 minutes to satisfy her fully in bed.

by Leon Pantenburg

It has been over 10 years since I started any wilderness campfire using any ignition method other than flint and steel.

Part of the reason is that I like to keep my survival skills polished, and the other is that flint and steel is just so effective. I’ve used the method successfully in driving rain and snow, wind and zero degree temperatures. But the old time method would not be my first choice as a survival fire making tool during an emergency.

My number one choice is a combination of cotton balls infused with petroleum jelly and ignited with a ferrocerium (also frequently referred to as a flint or magnesium) stick.

The method has a lot going for it as a survival fire starter: the small, one-handed-opening container I use holds three infused cotton balls, weighs virtually nothing, and doesn’t take much space. The infused cotton balls can be lit with virtually anything that produces a spark or flame. Properly infused cotton will burn for several minutes, and that alone will help coax a campfire out of damp tinder and wood.

Here is how to use the system:

survival firestarter cotton balls infused with petroleum jelly

Cotton balls infused with petroleum jelly make reliable and effective firestarters.

Before you go:  Get some extra-large 100-percent cotton balls and petroleum jelly. Pack as much jelly as you can into the cotton. Carry these in an easy-to-open, but secure container. Make sure these are close to your ferro rod for easy and quick access. While not crucial, I like to take along an aluminum foil yogurt container top, too. (Survival Expert Peter Kummerfeldt taught me this trick, and I steal it frequently and promote it shamelessly.)

To use:

  1. Remove a pinch of the fire starter from the container, and fluff it up as much as possible. The size of the pinch depends on a variety of circumstances, including dampness of the materials, weather, and the severity of the situation. If you desperately need to start a fire to prevent hypothermia, use a lot. If  the emergency in not particularly severe, take some extra time to gather more tinder and small sticks and use a tiny pinch.
  2. Place the cotton on the aluminum foil. The infused fluffed-up cotton will be sticky, so it will stay put on a flat log or rock, too. I like the aluminum foil trick because the concave foil makes the melted jelly pool, and that adds significant burning time.
  3. Point the end of the ferro stick at the base of the cotton. Get the stick as close a possible.
  4. Place the striker on top of the mag stick at a 90 degree angle. Position the edge at about a 45-degree angle, as if you want to whittle off some magnesium.
  5. Draw the mag stick back sharply, while holding the striker in place. There is tendency for people to want to “whittle” the mag stick with the striker. This works just fine. For beginners, though, I recommend drawing the ferro stick back, so you don’t scatter the firestarter if your hand slips.
  6. The shower of sparks should ignite the cotton ball. The cotton ball can also be used as fire starter with any other flame or spark source.

If you’ve done everything right, this process should take hardly any time. The  initial fire ignition should burn for several minutes. All you need to do is add, in this order, small twigs, larger branches and finally logs. Gather all these, and have them ready before you ignite the cotton ball.

Then, congratulations – you have a warm fire, and can think about the next step in your survival plan.

(My thanks to survival expert Peter Kummerfeldt, who taught me this technique several years ago. His eBook ” A Better Way to Build a Fire” is the most practical discussion about survival fire making I’ve come across. Check out Peter’s website by clicking on Peter Kummerfeldt.)

Amazon.com Widgets

Here is my go-to firemaking method for survival situations and how to use it.

A small ferro rod is an important tool in this keyring survival kit.

A small ferro rod is an important tool in this keyring survival kit. (Pantenburg photos)

However, these can be symptomatic of less sinister viagra prescription http://www.slovak-republic.org/orava/ conditions, as well. Endocrine System Diseases Endocrine system diseases and disorders are generally categorized into two categories. http://www.slovak-republic.org/itinerary/best-of-west-slovakia/ levitra on line One of these is the generic viagra in india Kamagra line of products. Sex is discount viagra pharmacy a mutually pleasurable and satisfying sex life.

by Leon Pantenburg

It has been over 10 years since I started any wilderness campfire using any ignition method other than flint and steel.

Part of the reason is that I like to keep my survival skills polished, and the other is that flint and steel is just so effective. I’ve used the method successfully in driving rain and snow, wind and zero degree temperatures. But the old time method would not be my first choice as a survival fire making tool during an emergency.

My number one choice is a combination of cotton balls infused with petroleum jelly and ignited with a ferrocerium (also frequently referred to as a flint or magnesium) stick.

The method has a lot going for it as a survival fire starter: the small, one-handed-opening container I use holds three infused cotton balls, weighs virtually nothing, and doesn’t take much space. The infused cotton balls can be lit with virtually anything that produces a spark or flame. Properly infused cotton will burn for several minutes, and that alone will help coax a campfire out of damp tinder and wood.

Here is how to use the system:

survival firestarter cotton balls infused with petroleum jelly

Cotton balls infused with petroleum jelly make reliable and effective firestarters.

Before you go:  Get some extra-large 100-percent cotton balls and petroleum jelly. Pack as much jelly as you can into the cotton. Carry these in an easy-to-open, but secure container. Make sure these are close to your ferro rod for easy and quick access. While not crucial, I like to take along an aluminum foil yogurt container top, too. (Survival Expert Peter Kummerfeldt taught me this trick, and I steal it frequently and promote it shamelessly.)

To use:

  1. Remove a pinch of the fire starter from the container, and fluff it up as much as possible. The size of the pinch depends on a variety of circumstances, including dampness of the materials, weather, and the severity of the situation. If you desperately need to start a fire to prevent hypothermia, use a lot. If  the emergency in not particularly severe, take some extra time to gather more tinder and small sticks and use a tiny pinch.
  2. Place the cotton on the aluminum foil. The infused fluffed-up cotton will be sticky, so it will stay put on a flat log or rock, too. I like the aluminum foil trick because the concave foil makes the melted jelly pool, and that adds significant burning time.
  3. Point the end of the ferro stick at the base of the cotton. Get the stick as close a possible.
  4. Place the striker on top of the mag stick at a 90 degree angle. Position the edge at about a 45-degree angle, as if you want to whittle off some magnesium.
  5. Draw the mag stick back sharply, while holding the striker in place. There is tendency for people to want to “whittle” the mag stick with the striker. This works just fine. For beginners, though, I recommend drawing the ferro stick back, so you don’t scatter the firestarter if your hand slips.
  6. The shower of sparks should ignite the cotton ball. The cotton ball can also be used as fire starter with any other flame or spark source.

If you’ve done everything right, this process should take hardly any time. The  initial fire ignition should burn for several minutes. All you need to do is add, in this order, small twigs, larger branches and finally logs. Gather all these, and have them ready before you ignite the cotton ball.

Then, congratulations – you have a warm fire, and can think about the next step in your survival plan.

(My thanks to survival expert Peter Kummerfeldt, who taught me this technique several years ago. His eBook ” A Better Way to Build a Fire” is the most practical discussion about survival fire making I’ve come across. Check out Peter’s website by clicking on Peter Kummerfeldt.)

Amazon.com Widgets

Here is my go-to firemaking method for survival situations and how to use it.

A small ferro rod is an important tool in this keyring survival kit.

A small ferro rod is an important tool in this keyring survival kit. (Pantenburg photos)

Each day millions of people irrespective of age and gender are passing through the acidic complications in form of heart burn, indigestion or in order viagra overnight certain other forms. If required, you can viagra generic discount secretworldchronicle.com seek help from a counselor who can assist you in coping with sexual dysfunction. The reasons why this medicine has maintained its position since last order viagra prescription http://secretworldchronicle.com/tag/chug/ decade and has been best for a number of things, which includes anemia. Kamagra kaufen now http://secretworldchronicle.com/2014/11/ sales cialis to have a pleasant life with your partner every day, then why don’t you make it more seductive and enjoyable? Make your sex climaxing by trying these different ways: – Connect your mind and body.

by Leon Pantenburg

It has been over 10 years since I started any wilderness campfire using any ignition method other than flint and steel.

Part of the reason is that I like to keep my survival skills polished, and the other is that flint and steel is just so effective. I’ve used the method successfully in driving rain and snow, wind and zero degree temperatures. But the old time method would not be my first choice as a survival fire making tool during an emergency.

My number one choice is a combination of cotton balls infused with petroleum jelly and ignited with a ferrocerium (also frequently referred to as a flint or magnesium) stick.

The method has a lot going for it as a survival fire starter: the small, one-handed-opening container I use holds three infused cotton balls, weighs virtually nothing, and doesn’t take much space. The infused cotton balls can be lit with virtually anything that produces a spark or flame. Properly infused cotton will burn for several minutes, and that alone will help coax a campfire out of damp tinder and wood.

Here is how to use the system:

survival firestarter cotton balls infused with petroleum jelly

Cotton balls infused with petroleum jelly make reliable and effective firestarters.

Before you go:  Get some extra-large 100-percent cotton balls and petroleum jelly. Pack as much jelly as you can into the cotton. Carry these in an easy-to-open, but secure container. Make sure these are close to your ferro rod for easy and quick access. While not crucial, I like to take along an aluminum foil yogurt container top, too. (Survival Expert Peter Kummerfeldt taught me this trick, and I steal it frequently and promote it shamelessly.)

To use:

  1. Remove a pinch of the fire starter from the container, and fluff it up as much as possible. The size of the pinch depends on a variety of circumstances, including dampness of the materials, weather, and the severity of the situation. If you desperately need to start a fire to prevent hypothermia, use a lot. If  the emergency in not particularly severe, take some extra time to gather more tinder and small sticks and use a tiny pinch.
  2. Place the cotton on the aluminum foil. The infused fluffed-up cotton will be sticky, so it will stay put on a flat log or rock, too. I like the aluminum foil trick because the concave foil makes the melted jelly pool, and that adds significant burning time.
  3. Point the end of the ferro stick at the base of the cotton. Get the stick as close a possible.
  4. Place the striker on top of the mag stick at a 90 degree angle. Position the edge at about a 45-degree angle, as if you want to whittle off some magnesium.
  5. Draw the mag stick back sharply, while holding the striker in place. There is tendency for people to want to “whittle” the mag stick with the striker. This works just fine. For beginners, though, I recommend drawing the ferro stick back, so you don’t scatter the firestarter if your hand slips.
  6. The shower of sparks should ignite the cotton ball. The cotton ball can also be used as fire starter with any other flame or spark source.

If you’ve done everything right, this process should take hardly any time. The  initial fire ignition should burn for several minutes. All you need to do is add, in this order, small twigs, larger branches and finally logs. Gather all these, and have them ready before you ignite the cotton ball.

Then, congratulations – you have a warm fire, and can think about the next step in your survival plan.

(My thanks to survival expert Peter Kummerfeldt, who taught me this technique several years ago. His eBook ” A Better Way to Build a Fire” is the most practical discussion about survival fire making I’ve come across. Check out Peter’s website by clicking on Peter Kummerfeldt.)

Amazon.com Widgets